2 points   🥚 Taming & KO       Report

Honestly everyone prolly knows this already but for those who don’t, use small metal gates and a few large bear traps. U will need about five to six gateways and at least three large bear traps. Place the first gate however you want it, the n place two more on either side of the first one diagonally.

Ex: _

/ \

Make sure you connect them. Place the bear traps inside the formation of gateways. Take note that you can extend the length of the two sides if you want.

Ex: /

/

(Sorry I can’t connect slashes but hopefully you get it)

Then lure the giga into the trap by going around to the front side and let him follow you into the opening so it will get stuck on the bear traps. Try not to get yourself stuck though. Then go to the back where the opening is and seal off the opening with the remaining gateways. The extra bear traps are if you can’t make it to the back to seal the trap off in time before he gets free. Another note: you cannot do this on a hill. It is very hard. Try to to this on flat ground.

Hope this was helpful!

More Giganotosaurus Taming & KO Tips